Go to navigation links
High quality decorative products

Sculptured Panels - Mesh

Sculptured Panel - Mesh Pattern: Black, red & yellow through-coloured MDF, coated with clear satin lacquer
  • Special order item in exact quantity required
  • Minimum thickness = 22mm
  • Pattern height = approx 9mm
  • Pattern repeats on all edges at size 2400x1200mm
  • Grooved or laminate balancer bonded to reverse
  • Mesh shown in black, red & yellow through-coloured MDF, coated with clear satin lacquer

Overview

Mesh is a repeating series of elongated oval shapes approx 200mm long and 50mm wide, with 17mm between the highest and lowest points of the surface. The design can be supplied as a single-layer or composite of multiple layers in minimum thickness of 24mm

Although it is available in a range of materials and finishes, and can be produced in specific panel sizes & sets, Mesh is typically supplied using coloured MDF in a standard panel size of 2400x1200mm

In detail

Because removing a lot of material from one side of any panel can cause it to cup towards the machined face, the panels are often ordered with a diamond pattern of relieving v-grooves machined into the reverse in order to help keep the panel as flat as possible.

Alternatively, a laminate can be bonded to the reverse or an additional panel such as 18mm MDF can be used in place of the laminate. This increases the overall thickness, but offers additional bulk to help with hidden fixings

This machined design repeats on a 2400x1200mm basis. However, we would advise against classing any design constructed of multiple layers of different colours as a repeating set

Information

Technical details (general)

  • Construction:
    • Single or multiple layers of through-coloured MDF or other suitable raw material with one surface machined to a deep, repeating pattern
  • Pattern height:
    • Approx. 7mm
  • Standard thickness:
    • Minimum 20mm
  • Standard sizes:
    • Produced to order in bespoke sizes
  • Pattern repeat:
    • 2400x1200mm
  • Maximum size:
    • Determined by material used and quantity required
    • In principle, panels can be supplied up to 3600x1500mm, but not as a fully matched set (max. size subject to availability of required material)
  • Finishing:
    • All items can be supplied raw or coated with various coatings such as clear lacquer or oil