Go to navigation links
Slip-resistant plywood in multiple surface patterns & colours

Slip-Resistant Plywood - Black Step Pattern

This product is only sold in commercial quantity, e.g. full pallet per item - we cannot recommend any resellers

Black Step pattern anti-slip plywood
  • Stocked in 18mm 1220x2440mm (loose sheets possible)
  • 4mm-30mm available to special order in pallet quantities
  • Maximum size 1525x3600mm
  • Typical pallet = approx. 2.8m3
    (e.g. 50 sheets 18mm 1250x2500mm)
  • Hazard Class EN 636-3 - suitable for fully exposed high-moisture conditions

Surface pattern

Winwood Products is a supplier of the following Black Step pattern slip-resistant plywoods:

Black Step pattern slip-resistant plywood

This slip-resistant, exterior plywood is overlaid with a UV-resistant patterned polypropylene coating that has anti-slip properties. This coating is bonded to the core plywood using an elastic, two-part glue that meets D4 requirements for exterior uses.

The UV-stable anti-slip coating maintains its colour even when exposed to changing climatic conditions, and provides a hygenic & easy-clean surface.

The surface covering of this slip-resistant plywood is environmentally-friendly. It does not contain any chlorine derivatives, and is taint & odour free.

Information

Technical details (general)

  • Construction:
    • Exterior birch plywood faced with a slip-resistant, patterned polyolefin coating that offers enhanced safety in the form of a resilient and water-proof anti-slip surface
  • Standard thickness:
    • 6.5mm, 9mm, 12mm, 15mm, 18mm, 21mm, 24mm, 27mm, 30mm
      (plus surface coating)
  • Standard sizes:
    • Made to order up to max. 1525x3600mm
  • Special sizes:
    • In principle, any size can be produced up to the maximum stated above
  • Surface coating:
    • UV resistant - similar to RAL 9004
    • Good colour stability (6-7 according to DIN 54004)
    • 1.15mm thick slip-resistant polyolefin surface coating with smooth polyolefin balancer, unless otherwise agreed
  • Edge treatment:
    • Typically sealed with exterior acrylic paint to protect against moisture
    • Notes:
      1. If the panels are subsequently cut to size, any newly exposed edges must be fully resealed using a suitable exterior protection system (e.g. acrylic paint)
      2. Rounding any sharp corners & edges will greatly help in the resealing process, as this will better allow the paint to fully adhere
      3. It is also highly recommended that after drilling holes or similar other areas where the water-resistant protective surface has been broken are sealed in a similar manner
  • Wear rating:
    • Taber abrasion value = 3500R-5400R
  • Tolerances:
    • Length/width: up to 1m @ ±1mm, up to 2m @ ±2mm , 2m & above @ ±3mm
    • Thickness: +0.2mm, -0.5mm
    • (Others by arrangement)
  • Specification:
    • EN 636-3 - Exterior & high moisture applications
  • Bonding Quality:
    • EN 314-2 Class 3 - Exterior
    • E1 (EN 13986) Low formaldehyde, CARB II, ULEF (Ultra Low Emitting Formaldehyde)