Go to navigation links
Slip-resistant plywood in multiple surface patterns & colours

Slip-Resistant Plywood - Auto Pattern

Auto pattern anti-slip plywood
  • Special order item
  • 4mm-30mm
  • Maximum size 1525x4000mm
  • Typical pallet = approx. 2.8m3
    (e.g. 50 sheets 18mm 1250x2500mmy)
  • Hazard Class EN 636-3 - suitable for fully exposed high-moisture conditions

In detail

Winwood Products is a supplier of the following Auto pattern slip-resistant plywoods:

Auto pattern plywood: Scan of anti-slip surface coating (approx. size = 135x90mm)

This slip-resistant, exterior plywood is overlaid with a UV-resistant patterned polypropylene coating that has anti-slip properties. This coating is bonded to the core plywood using an elastic, two-part glue that meets D4 requirements for exterior uses.

The UV-stable anti-slip coating maintains its colour even when exposed to changing climatic conditions, and provides a hygenic & easy-clean surface.

The surface covering of this slip-resistant plywood is environmentally-friendly. It does not contain any chlorine derivatives, and is taint & odour free.

Information

Technical details (general)

  • Construction:
    • Exterior birch plywood faced with a slip-resistant, patterned polyolefin coating that offers enhanced safety in the form of a resilient and water-proof anti-slip surface
  • Standard thickness:
    • 4mm, 6.5mm, 9mm, 12mm, 15mm, 18mm, 21mm, 24mm, 27mm, 30mm
      (plus surface coating)
  • Standard sizes:
    • Made to order up to max. 1525x3600mm
  • Special sizes:
    • In principle, any size can be produced up to the maximum stated above
  • Surface coating:
    • UV resistant - similar to RAL 7001
    • Good colour stability (6-7 according to DIN 54004)
    • 0.2mm thick slip-resistant polyolefin surface coating with smooth polyolefin balancer, unless otherwise agreed
  • Edge treatment:
    • Typically sealed with exterior acrylic paint to protect against moisture
    • Notes:
      1. If the panels are subsequently cut to size, any newly exposed edges must be fully resealed using a suitable exterior protection system (e.g. acrylic paint)
      2. Rounding any sharp corners & edges will greatly help in the resealing process, as this will better allow the paint to fully adhere
      3. It is also highly recommended that after drilling holes or similar other areas where the water-resistant protective surface has been broken are sealed in a similar manner
  • Wear rating:
    • Taber abrasion value = 2350R-4000R
  • Tolerances:
    • Length/width: up to 1m @ ±1mm, up to 2m @ ±2mm , 2m & above @ ±3mm
    • Thickness: +0.2mm, -0.5mm
    • (Others by arrangement)
  • Specification:
    • EN 636-3 - Exterior & high moisture applications
  • Bonding Quality:
    • EN 314-2 Class 3 - Exterior
    • E1 (EN 13986) Low formaldehyde, CARB II, ULEF (Ultra Low Emitting Formaldehyde)